Eon Decking – Composite Decking That Looks And Feels
Like Wood
By Peter Leigh
Eon decking is a revolutionary kind of decking that gives the appearance
of a deck built from real wood. There are six natural colors to choose
from. With Eon as your choice, you no longer have the problems of
splitting, cracking or rotting wood. Eon decking is made from
manufactured or recycled plastic. It does not contain any wood and the
material carries warranties against any defects. With Eon decking, there
is a special fastening method you have to use to make sure the
warranties will remain in place.
There is no difference in the texture or the color of each board
in Eon decking. This enables you to have a uniform deck.
However, to avoid eon decking problems, like other types of
composite decking, it is recommended to buy enough decking to
finish your project at the same time. If you should happen to
run out of decking, there may be a problem getting exactly the
same color in the next batch. The Eon warranties do cover the
color, which is supposed to remain true for the life span of the
product.
Some homeowners have reported Eon decking problems, but when
inspectors visit the site, they have determined that the problem
is with the installation and not the Eon decking material
itself. |
|
|
For example, Eon recommends that this decking be
left floating, so it is screwed too tightly it will crack. Another
problem that homeowners report is the surface scratches that may appear
on the decking. Eon says that these will disappear when the material
becomes acclimatized. You may also notice some creaking when you walk on
it, but since this is seen as an installation problem, Eon warranties
will not cover it.
Eon decking is easy to install. You do not have to use any surface nails
that might mar the look of the finished deck. Instead, you do have to
use special T-clip fasteners. Homeowners who feel that these fasteners
are not strong enough and use other methods of securing the decking to
the frame run the risk of voiding Eon decking warranties. Then when Eon
decking problems arise, the warranty will not cover the cost of
correcting the problem.
Eon decking can be cut and drilled just as wood. However, it is
recommended that you use a saw with carbide tips and use rapid cuts. The
best cuts for Eon decking can be achieved with a handsaw or a mitre saw.
Any surface abrasion is easy to remove with sandpaper and to clean this
decking all you have to do is wash it down with the garden hose.
To find out more about Decking visit Peter's Website The Decking Guide
and find out about
Composit Decking and more, including Wood Decking, IPE Decking, Trex
Decking and Pool Decking.
|
